/dist/images/branding/favicon
Separate names with a comma.
Switching over from MK to DJI any suggestions on affordable esc? Running Axi 2814 motors.
Has anyone flown this configuration? I've had it with MK. I just don't trust it and have had way to many issues concerning reliability. (Andy I...
Cinestar 8 with MK electronics and 3 axis gimbal. Today we were doing some tests flights with no problems. We landed switched batteries and...
My bird started toilet bowling went out of control and crashed. Fortunately it as about 15 or so feet off the ground so there was no serious...
Okay. So I took the beast out today and tried to calibrate the compass in the hope it would finally correct my GPS issues. No matter how I...
A while back I had issues with my GPS and PH. I finally figured out that even though MK Tools was telling my compass was calibrated it was in fact...
So low and behold tomorrows was going to be a big day. I was going to bring the bird on set and my pilot was coming down for a couple of hours to...
Question. I have a 2C 1900 to power Radians, Servos and Iftron. Right now I have a BEC wired on after the Lipo which is delivering 5.8 Volts. My...
Just when I thought I had this wrapped project wrapped up and ready to actually bring on set I have some problems. This is out of the blue. My...
Beautiful day here in Rome. Air was crisp but not freezing with a slight wind. After having made the appropriate adjustments that my brethren...
After months of working through all the issues today was supposed to her maiden flight. I'm just the camera dude and the enterprising soul who...
Can I power the HDMI off of one my radians?
Has anyone direct wired from the Distro board to the FC? I read on another forum how the molex cable is a devil in disguise and not trustworthy....
Well I'm finally coming to the home stretch after multiple issues. The biggest on was sending the distro board back to MK Germany not once but...
Hey guys I can't seem to invert the pan controls on the Graupner. Right now then pan axis pans right when I stick left. I want to switch it in the...
I'm using a Graupner mx16 with a cinestar 360/radian. I don't have a full tilt range. At a camera level position when I tilt down I get maybe 45...
Hey All, I've assembled the airframe and gimbal. Balanced it out, then set it up over 2 chairs so the gimbal hangs down between the chairs. I...
I have an Mx 16 destined for camera control. What are the correct channel settings for pan , tilt and roll in the Radian software setup. I want to...