/dist/images/branding/favicon
Separate names with a comma.
Yes, but it didn't really 'throttle back'. Rather, it lost power and fell from the sky. Upon examination of the board afterwards, it appears...
1 hour after I post is not exactly late, Andy... I'll take some shots back at the studio shortly. B.
That is odd. Will look closer. However, I don't think that should explain the sudden loss of power... B.
Howdy... So, after several successful flights yesterday, today I had a disaster... Took off under calm conditions. Hovered for 20-30s in a...
I'll post one when I'm back in town net week. However, bad solder joints would cause the correlation that you're seeing, no? This was a dead...
Howdy... So, the QC folks replaced ALL my motors, and I have a brand new PDB. Checked and double checked everything. Balanced and leveled ,...
So Joe, you're saying that if you turn off the compass influence in MKTools, you can still use Carefree as it was intended? Can anyone confirm?...
Howdy... So, I took one last flight today before RMAing all my motors to go back to QC to check for bearing issues. I'll be out of town for 3...
I also believe you need the compas for 'Carefree' mode, no? Best, Ben
Howdy... Does anyone know if it's possible to set a maximum speed for climb or descent in AH? When I'm quite high, it's fairly difficult to tell...
Not sure that's quite true. We've had a BL fail in flight and just shut down one motor. It probably depends on how it fails... Some sort of direct...
From what I can see, the heli doesn't, in fact, flip over. Rather, it appears to be flying to the right. The pilot attempts to slow it down by...
It'd be ok if the setting was respect to 'level'. For example, when the radians are initialized on the ground, they calibrate to 'level'. Then...
Howdy... I'd like to request a feature that I hope wouldn't be too difficult to impliment for the next version of the firmware, and that would...
...and I'll happily come along to take photos / video / and document everything for you :) B.
It was a text message. The soldering is solid, as far as I can tell... B.
I don't get it myself, unless there's something wrong with the motors. If it was a balance issue, you'd expect opposite motors to have opposite...
OK. Think I found it... It's channel 8 on the TX, and the receiver needs to be set to Bank "B" channel 8.... Man...they don't like to make...
So any idea which channel is that on the receiver? ...and why does QC offer this as "• 8 channels DIP switch selectable." Best, Ben
Howdy... I have the lawmate transmitter/receiver from QC. The lawmate is supposed to have 8 channels, I believe, however the dip switches...