/dist/images/branding/favicon
Separate names with a comma.
I loaded MKtool 1.8b and it seems I have everything working/NOW to test fly. thanx for the help. steve
I'm bad! For the last 2 days I have been using the wrong pins on the Nav bd. I was unplugging the FC on the Navi bd and plugging in the usb...
Andy I am using 90j for the FC and trying to load 30h for the navi bd. I am hooked up through the FC, but I have alsotried directly to the Navi...
still getting the message. I regarded down to the last, but the MK tool shows the downgrade of the Navi bd is the same as the FC bd - 90j
here is what is left on the screen when it denies me
I will try to send the pic again.
I have not moved any of the wiring other than to try to connect directly to the navi bd. The FC did take first with a direct connect to it....
here is the error message, thanx, steve
Aircraft Type: C6 Gimbal Type: 2 axis FF Camera/Lens Being Flown: gopro MK Stack: FC Navi GPS Flight Radio/Recv Type: Graupner MX20 Software...
I know things have changed quite abit out there. I am about to retire as firefighter, 10 in Greeley and 30 yrs here in Florida. I thought this...
gary, I changed the camera nick to poti7 and everthing is working and reset the limits. thanx for the help, steve i lived in greeley for 20 years
I don't have a smart phone, but your picture is the same I have on my MX screen. Here is a screen shot of the channels. thanx, steve
here is my attempt at the screen shot (pdf) I am using the MK flight controller and the control 6 radial switch by sw#1 on the MX20. The control...
I have been trying for some time now to have a poti on the MX20 control the camera angle. I have the 2 axis gimbal from QuadroCopter on a C6. I...
howdy, i have some video of waterfalls that i shot from the quadcopter., but it is not fpv. and i don't really know what the gpx file is. i did...
I am trying to setup the gimbal from freefly? the nick is doing fine but the roll poti is not. The poti will not compensate for the roll, but...
thanx Andy. I thought i ruined my battery, went to 9.7 volts until i figured out why the C6 was beeping rapidly. I used the recover technique you...
I am new to this game. I have just finished the build on a Cinestar 6 and had some problems initiating the communications between the controller...