Programming Graupner transmitters question

Discussion in '3 Axis Gimbal' started by Mike Reid, Nov 10, 2013.

  1. Mike Reid

    Mike Reid Member

    Joined:
    Jul 14, 2013
    Messages:
    126
    Likes Received:
    11
    After having my Mōvi for a while I have become really use to the pan and tilt speed being adjustable on the fly. I have been testing to see if I can figure out how to do it on my MX-12, but haven't had success yet.

    I'll keep reading through the manual to see what I come up with, but if anyone out there is knowledgeable in graupner and knows how to get one channel to adjust the speeds of the pan/tilt on the fly and suggestions would be greatly appreciated!

    Thanks,

    Mike Reid
     
  2. Gary Haynes

    Gary Haynes Administrator
    Staff Member

    Joined:
    Jul 6, 2012
    Messages:
    5,211
    Likes Received:
    460
    Correcting my post. Mike the MōVI only works with s.Bus (Futaba) and Spektrum. It doesn't currently work with PWM or the PPM from a Graupner.
     
  3. Mike Reid

    Mike Reid Member

    Joined:
    Jul 14, 2013
    Messages:
    126
    Likes Received:
    11
    I have the MX-12 for my gimbal operation and the MX-20 for flying.

    One part that I had left out is that I am trying to do this for the MX-12 with my CS 3 axis servo gimbal with radians. I have that dialed in to nearly perfect, so I am keeping the movi separate to work on its own.

    Thanks for the quick reply Gary!
     

Share This Page