How to get WCU-4 cforce mini motors working on MoVi PRO?

Discussion in 'Follow Focus' started by Timothee Ferreira, May 31, 2017.

  1. Timothee Ferreira

    Timothee Ferreira New Member

    Joined:
    May 31, 2017
    Messages:
    4
    Likes Received:
    0
    Hey there, i have been wanting to connect our cforce mini motors to the MoVi Pro but the connectors for the Cforce mini motors are lemo fgg.0b (iv attached a picture of what it looks like) while the MoVi pro FIZ connectors are lemo fgg.1b

    I want to know if i can swap the connector of the one end of the cforce cable to the MoVi Pro Molex microfit connector so i can it on the MoVi pro?

    Thanks in advance!!
     

    Attached Files:

  2. Andy Johnson-Laird

    Andy Johnson-Laird Administrator
    Staff Member

    Joined:
    Jul 31, 2012
    Messages:
    10,347
    Likes Received:
    1,159
    Hi Timothee: If you don't get an answer from forum members, I suspect you'll need to email to Freefly Support (support@freeflysystems.com).

    Cheers
    Andy

    Forensic Software & sUAV / Drone Analyst : Photographer : Videographer : Pilot (Portland, Oregon, USA): Trees=2, Ground=1, Props=11. :(
    The Ground Is The Limitâ„¢
    ---------- Forensic Drone Analyst : Forensic sUAV Analyst : Forensic Unmanned Aircraft Analyst : Forensic Drone Expert
     
  3. Nick Timmons

    Nick Timmons New Member

    Joined:
    Dec 17, 2016
    Messages:
    6
    Likes Received:
    0
    Unfortunately, the answer is no. I'd love to use my Arri motors (I have CLM and L-bus type motors myself), but it's not possible...
     

Share This Page