Flashing leds after upgrade on my M10

Discussion in 'MōVI M10' started by Erik Estrada, May 29, 2017.

  1. Erik Estrada

    Erik Estrada New Member

    Joined:
    May 29, 2017
    Messages:
    2
    Likes Received:
    0
    Hello and good day to all, I just did the update of the firmware of my m10 this morning, but now when it turns on it does not stabilize and the 3 LEDs are flashing, I have reset the bootstrap cable but nothing happens either, alguine knows why it happened This and how to fix it, I'm from Mexico, thank you
     
  2. Andy Johnson-Laird

    Andy Johnson-Laird Administrator
    Staff Member

    Joined:
    Jul 31, 2012
    Messages:
    10,369
    Likes Received:
    1,162
    I've responded to your other posting, Erik.
    Andy

    Forensic Software & sUAV / Drone Analyst : Photographer : Videographer : Pilot (Portland, Oregon, USA): Trees=2, Ground=1, Props=11. :(
    The Ground Is The Limit™
    ---------- Forensic Drone Analyst : Forensic sUAV Analyst : Forensic Unmanned Aircraft Analyst : Forensic Drone Expert
     
  3. Chris Bernard

    Chris Bernard New Member

    Joined:
    Oct 5, 2016
    Messages:
    8
    Likes Received:
    0
    Check ALL motor leads. the pan axis motor comes loose commonly. make sure the lead is seated firmly in.
     

Share This Page