Separate names with a comma.
G'day again , the lower two, altitude and yaw are both around 100. Cheers, Dan...
G'day Jason, I have a X8 DJI WK and the gains for roll and pitch are up around 170 for both. From memory the roll is slightly higher. I have the...
Have you tried smaller props...? Dan...
G'day Tristian, I have the same or very similar set up, so hopefully I may help. My craft has the same blades on top and bottom. APC 14x4.7....
I was under the impression only the IMU was flashing as the Bluetooth Led is remaining solid. Either way, does it alter the signally lights in any...
Will the flashing remain the same if you increase the gain on the roll and pitch of the IMU…?
G'day Paul, How is the craft handling…? Other then the lighting, is it twitchy, sluggish. Have you had it flying well before on another system...
G'day Chris, Can you point me in the direction of the picture which shows the solder points...? Thanks, Dan...
Any words of wisdom about using these Tiger motors for a heavy lift CS8...? They'll have a 40Amp ESC each and I am thinking a 6S power supply....
Thanks for the feed back, very interesting. The reason I use the stabilization in the FPV camera is that it makes the piloting smoother. I...
Is it possible and if so how does the MK FC2.1 stabilise a Gymbal for a FPV camera...? I have the control of two servos for the gimbal working...
G'day John, The firmware loaded successfully after I loaded the version Andy sent me, almost nano seconds after I posted the question. It might...
G'day Andy, can you asssit...? I'm in bootloader mode, both orange and green lights on solid. I have the new 1.1 Bootloader software and am able...