Separate names with a comma.
Aerial Footage in Kazakhstan, Almaty: https://www.facebook.com/photo.php?v=223100061217109...
Hi all, I read Radian FAQ, but there too didn't find the answer to the question. I have such problem: It is impossible to activate the "MODE...
Hitler's reaction to Blackmagic Cinema announcement... [media]
Jei, after 5DMk, GPH3 it isn't serious.
And still, welcome the best way for synchronization of collaboration of the operator and the pilot is an existence 2 sets of OSD, with compasses...
Hi Andy, You mind to tell the young people of the community Radian, basic recommended configuration settings on all axes, for optimal performance?...
I set up speed servo in RC transmitter using Dual Rates & Exponent. This can get very slow and smooth motion servo.
Yes, you can easily manage only Tilt & Roll, without the Pan axis. All three axis modules Radian, absolutely identical and independent of each other.
Mark, you have overcome your problem related to the instability of the module efficiency Radian, which is set for an axis pan? I had a similar...
Gary, so far I have not changed specifically modules places, as they are beautiful, each glued to his seat. Tomorrow, I can switch to other cables...
Colin, I initially too had a thought that is the defective module. But nevertheless, it several times was normally efficient! I have a thought...
Andy, and when in November I received new Radian, I checked the firmware version. There was version 1.03 is established. But besides, I loaded...
Port 2 of the Pan sensor meanwhile at me isn't connected anywhere and hangs the free. This port is supposed to be used from the discrete channel...
Hi Andy, Thanks for the answer. I apologize concerning a name, I didn't know about so severe rules at your forum. Already I changed a nickname....
Hi all, I'm using the Cinestar 3 axis gimbal with 3 Radian stabilization modules. The "Tilt" and "Roll" axes work perfectly! But there is an...