The only Bluetooth device is the movi... So unless I'm doing the wiring circuit wrong, I have no idea... I'll send you a picture shortly and check if I'm doing it correctly... Again thanks for all your help and suggestions
Sorry....been off line. Here's a link: https://www.dropbox.com/s/2dbg2qdj5uwy08e/MoVI-v3.08-Release.zip?dl=0 Andy.
Hi Andy, Still won't work, thanks for all your help...I think I'll have to wait to get the jumper cable and see what happens...I'm a little concerned there may be some sort of other issue.
I agree with you that there might be some other issue -- I've not seen this problem reported before. Telediagnosis is hard to do without asking what seem like dumb questions, but, with that in mind let me ask one other question: did you fall back to using the 3.08 version of the Configurator app to try and "upgrade" to version 3.08 of the firmware for the MōVI gimbal controller? I would also double check that the pin 1-5 shorting wire is making good contact....it's such a basic mechanism -- the MōVI's microprocessor is simply forced into the bootstrap loader mode on power up when those pins are shorted together -- there's no "intelligence" involved in the decision -- for which read, there ain't much to go wrong! Could you drop me an email to ajohnsonlaird AT me DOT com please? Andy.
Andy, I didn't change to 3.08 configurator software.... I've ended up shooting it handheld on f55, not what I wanted but we got there....I'll send you an email shortly, back in LA where I have a cable waiting for me...