Hello, I bought FUTABA T10J + R3008SB reciver and I can connect to movi? Reciver is bind. Movi software can't see radio controler?! Please help!!!
I believe you will have put in a s-bus and connect to your R3008SB receiver. Otherwise the m5 wont recognize the Futuba.
So you need a s-bus encoder. http://www.futaba-rc.com/sbus/futm4194-lg.jpg Then take off the two screws where the spektrum cable is. remove this cable this not required then plug in your s-bus encoder into the slot. then from your s-bus encoder just plug in the cables into your R3008SB receiver. Then change the receiver type in the MoVI GUI to s-bus. You will then need to program the channels using the movi gui
We only use Futaba products so I know exactly what your problem is. The Futaba T10J ships with a telemetry enabled receiver unit that won't work with Freely products. This is the same issue others have experienced with the receivers that ship with the Futaba 14SG and 18MZ. To fix the problem, you just need to buy a different receiver. The kit R3008SB transmits on T-FHSS ("T" stands for telemetry). You need the S-FHSS ("S" stands for surface) version of that receiver. Buy this and everything will work normally, although you won't get telemetry data back to the transmitter. http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXBPKN&P=ML
I have The Futaba T10J & the Futaba R3008SB working with the MOVI M5. The only thing I cant figure out is the Pan which for my Multirotor application that is the most crucial control. If anybody has any tips or advice You input would be greatly appreciated Thanks
Christopher check your channel mappings on the both the radio and in the MoVI gui. Might simply be a channel mismatch.