Assigning open inputs for DIY Thumbwheel

Discussion in 'WEDGE' started by Joshua Binder, Jun 9, 2015.

  1. Joshua Binder

    Joshua Binder New Member

    Dec 7, 2013
    Likes Received:
    I'm seeing more and more options for assignable ports opening up in the software.

    I'm wondering with the wedge if I were to DIY an appropriate rotary encoder circuit would I be able to route through either the extra ports on the wedge or any of the inputs on the Movi itself to control focus.

    Basically could I build another simple control and wire it into the system and assign it to control Focus via the Movi controllers FIZ settings .

    GPIO I imagine won't work since some sort of PWM input would be needed.

Share This Page