Separate names with a comma.
Here: http://carvecsystem.co.uk/g-lock :)
Hi, Overshooting or not? Do you know if there is a way to find if a oscillation of the gimbal is due to a over or a under gain? I mean when Roll...
Hi Andy, I don't really have problemes with my Radians but I am sure it's possible to improve it. I think that's could be better with Roll tuning...
Yes, that's what I say: this product is getting dead ............. You don't think it may be improved ...... a bit, a lot?
Euh, no, I was asking about a Radian upgrade.
Hi Andy, Do you have intention to make a new version after this 1.03. Seem to me that this product is a (little bit) dead! Don't you? Regards....
I just hope you are not joking. That will be too great a such feature. :)
I completely agree with John Fox when he said: "The problem with a single board controlling all 3 axis is the complicated mathematical equations...
Don't keep these messages but I send my messages to support@hoverflytech.com. New version features:...
I have buy a Hoverfly gimbal about 2 month ago. What can I say: Some calibrations are necessary; and you have to frozen and let get warmer to...
Hi Andy, Again, thanks for all. Could I say that, in my point of vue, this is not the best way to make some slew angle. I think the most natural...
Hi Andy, Yes, you are right, that unfortunatly his normal behavior. Not a too big problem, but I think that's not the good option. Many...
As I can see, it's easy to get the tilt level at start up. With the Software connected, make very small movement down on your stick and you will...
Hi Andy, I am really sorry all of that dont change some thing. Always the same: angle change until I go back with the pot. To simplifly, I...
Hi, I get the same problem if I supply power to port 2. But I don't have a loop back between roll and tilt; just a connection from port 3 tilt...
Hi Andy, Tilt Radian connections: 1: Receiver to angle change (Via pot) without red wire. 2: 3: Go to Radian Roll 4:Tilt servo Roll Radian...
Hi Andy, Thanks to reply. What I do is to connect a receiver output (that is commanded with a pot) to Radian tilt input 1. I do that to change...
I put a potentiometer to adjust my tilt angle and when I make a move with the pot, angle increase or decrease but the movement don't stop until I...
I have also some problem with XP: - PC Software 1.0.1 is installing and run well. - During Setup of Bootloader programm I get the message "Setup...
Don't forget to upgrade your GR24 too. You must use version 33512_gr_rx12_3a70_bf.bin and (version 1v126.bin for your MX20).