Separate names with a comma.
Ohh yes i forgot about. 4s 5000 2x, lifting a cx730 camera. Motors axi 2826/12 e-props 14x8
would help if more people share their settings
thank you Andy i ll check your points. we also use the red ones.
what dampener orings are u guys using with the cx730/760= we still fighting some light vibrations.
Very interesting. i don't see any reason to go for the wookong. as for now naza also supports 8 rotors. would be great to hear some other people...
so it is not possible to put those wiredampers on a cinestar?
we put off the radians and we still got vibration. i also have to say that it is very cold here. -10 degrees.
Hi. We did some first tests today. But the result looked not that good. First part is inside and already here you can notice some vibration. It...
what gains do you achieve on the pan axis with the cx760 on it? if i go higher than 50% the gimbal starts to oscillate. regards
Thank you. And what about the horizontal bars. They need a bit of an angle upwards? Like on my photo. How much ideally?
I don't get it lol. Can you explain it on this photo. Thank you.
ok thank you. :)
does the tilt radian module needs to be in parallel with the camera plate?
Hi. Here is our Cinestar 8. it was build by a swiss company called Aerodron We are also from switzerland :) Today we had the maiden. Very excited...
okay thanks andy :) i think i ll give this cam a try :)
they are too stiff then. this is on the 3 axis gimbal?
that could be a problem, no? too bad the offer for the red scarlett is already over :)
don't you think the cx760 is too light for a cs 8? we also consider to get this camera instead of the fs100.