Quick Question. For those of you using the Futaba 8fg or 14sg I am using x2 and x3 channels for remote gain tuning. Is it possible to set up the radio to still have a switch for failsafe? I was hoping to use SE for manual, atti, gps atti, and then use CONDITION so that when SE is in gps if i flip SF on then it goes into FailSafe. I can get it in the radio to show it going to either idle up 3 or HOLD, whichever i set it to. Just wondering if it is possible to make the WKM go into FailSafe using this method? Am i missing something simple? I used to do it with my Vbar and bank switching but can't figure it out with WKM