What are some of the tools that I should have around for working on my CS that I might not have or wouldn't expect to need? I want to be prepared for any surprises, but with limited CS and MK experience, asking for this communities advice!
Soldering iron and heat gun, with solder and heat shrink of various sizes Full set of screw drivers, hex drivers and nut drivers in metric sizes An electric screwdriver Crimping tool, JST connectors, servo connectors, etc... Multimeter or other electrical tester Plastic boxes for little parts A small ruler That's all I can think of right now.
I think the best way to get out of trouble is to have another cs ready to go on the trunk. And once you finish your day you try to fix the first one. Any minor fix on the set will take longer than what will be tolerated by a director. Just my 2 cents