/dist/images/branding/favicon

Stock default setting for roll slew rate?

Discussion in 'Radian' started by Dave King, May 3, 2013.

  1. Dave King

    Dave King Well-Known Member

    Joined:
    Dec 24, 2012
    Messages:
    2,712
    Likes Received:
    311
    I was tweaking the settings back and forth and now I want to back to stock settings. Is it 60%?
     
  2. Andy Johnson-Laird

    Andy Johnson-Laird Administrator
    Staff Member

    Joined:
    Jul 31, 2012
    Messages:
    10,383
    Likes Received:
    1,164
    Hi Dave:
    Going from memory, yeah, 60 degrees per second (not a percentage).
    I suspect if you start up the software without any connection to the Radian, then click on the Roll-1 button, it will show you the defaults -- but I'm going from memory and it's been a long week.

    Andy.
     
  3. Gary Haynes

    Gary Haynes Administrator
    Staff Member

    Joined:
    Jul 6, 2012
    Messages:
    5,211
    Likes Received:
    460
    Yes the Roll/Tilt/Pan buttons default to factory settings. Just don't click Write and wipe out your previous hard work. Screen shots before can be a life saver.
     
  4. Dave King

    Dave King Well-Known Member

    Joined:
    Dec 24, 2012
    Messages:
    2,712
    Likes Received:
    311
    thanks guys. I have a significant roll twist that I'm trying to isolate down. I think it was just a combination of the roll balance being off and too much gain. I'll know for sure as soon as it warms up a little.
     

Share This Page