/dist/images/branding/favicon

Roll axis drifting when apply rocker knob

Discussion in 'MōVI Controller' started by Rozle Bregar, Feb 10, 2018.

  1. Rozle Bregar

    Rozle Bregar New Member

    Joined:
    Feb 9, 2018
    Messages:
    3
    Likes Received:
    0
    Hi,

    I have a Movi Pro and Movi controller latest firmware. I have applied Roll control on a Zoom rocker and roll axis starts drifting slowly, approx. 1 degree per minute. Before was ok, also in Majestic mode everything works fine. Is it possible to set up a trim for a roll somewhere, like you can do it for a pan and tilt axis?

    Thank you
     
    #1 Rozle Bregar, Feb 10, 2018
  2. Graham Futerfas

    Graham Futerfas Well-Known Member

    Joined:
    Oct 19, 2015
    Messages:
    1,261
    Likes Received:
    245
    Does it drift if you assign it to any other knobs, like Focus?
     
    #2 Graham Futerfas, Feb 10, 2018
  3. Rozle Bregar

    Rozle Bregar New Member

    Joined:
    Feb 9, 2018
    Messages:
    3
    Likes Received:
    0
    No, It is not drifting there.
     
    #3 Rozle Bregar, Feb 10, 2018
(You must log in or sign up to post here.)

Share This Page