Red RCP cable & Red start/stop cable

Discussion in 'MōVI Pro' started by Tyler Oxendine, Jan 20, 2017.

  1. Graham Futerfas

    Graham Futerfas Well-Known Member

    Joined:
    Oct 19, 2015
    Messages:
    1,208
    Likes Received:
    234
    Gerfried Guggi and Bryan Edmonds like this.
  2. Gerfried Guggi

    Gerfried Guggi New Member

    Joined:
    May 15, 2017
    Messages:
    20
    Likes Received:
    1
    got this cable last week, I think it should work with most RED configurations on MoVI.

    I also want to point out, since a few guys in this thread had problems getting the RCP connection to work: I had the same problem. Communication protocol in RED was set. Tried for half an hour without success, then I reset the MoVI to the Freefly default settings in the configuration loader (I had built the in-app configuration from a previous profile). Worked instantly and I just reentered my stiffness values and other settings.
     
  3. MaxBest

    MaxBest New Member

    Joined:
    Aug 20, 2017
    Messages:
    9
    Likes Received:
    0
    Hello! I have a RED Scarlet W 5K. It has DSMC2 BASE EXPANDER and RED DSMC2 Jetpack Expander (HDMI). How do I connect a universal Start-Stop cable? I use movi controller, movi m10, movi controller receiver and start-stop cable. When I press the REC button on the movi controller, the red light on the universal start-stop cable flashes once. But the camera isn't responding.
     
  4. Graham Futerfas

    Graham Futerfas Well-Known Member

    Joined:
    Oct 19, 2015
    Messages:
    1,208
    Likes Received:
    234
    Does it work on either of the expander modules, either the JetPack or the Base Expander? I think those two modules use different run/stop protocols, and Red changed their protocol after the original Base Expander.

    RCP control is different from Run Stop.
     

Share This Page