Hi guys, I've been banging my head on the walls here for day tring to figure this out... I want to connect my Spextrum JR9 transmitter to a Spectrum receiver for a 2 axis 2 operator radian setup. The 2nd operator would only be able to tilt. My problem is this, I've bound the satellite receiver to the JR9 and connected it to the radian. In the channel monitor window the channels dont make sense as some swiches move more then one channel. Even weirder is that when I try to configure the roll radian the channels are not the same then the tilt radian! So I used another receiver and I get different channels moving then the first receiver! I dont understand... Why would the elevator stick move channel 8 on one Radian and channel 4 on the other Radian? And why would the channels change from one satellite receiver to the other? Also, I have a 3 axis setup that I use with the same JR9 and that works just fine. There must be something basic here that I'm missing. Thanks for your help.