I have already removed this blue componment. Please see these pictures. Am I supposed to do something now? Is this a resistor pack?
Can you tell me step by step how to physically remove it, please? The three axis was not working after we had removed the blue component. Do the above three pictures show a resistor pack? Can the blue component be replaced with a resistor pack?
You should have 3 resistor packs, one for each servo. They plug into the short lead on the servo where the original blue potentiometers were originally plugged in. From memory to remove the blue potentiometer there is a set screw on the pot shaft that goes into the large tooth wheel. Back that off, detach the pot holder from the frame and it should slide out of the wheel. Also the resistor packs should have shrink wrap over the components to protect them from shorting out.
The resistor packs make the servo think it is in the center position all the time, I believe --- this fools the servo into allowing it to turn continuously in either direction. Tabb knows the real answer if it is not this. Andy.
I have removed this blue componment. And then made the resistor packs. But it was still wobble. It is so frustrating.