MoVi + wired Redtouch

Discussion in 'MōVI M10' started by Arturo Bernardi, Dec 5, 2013.

  1. Arturo Bernardi

    Joined:
    Aug 24, 2013
    Messages:
    50
    Likes Received:
    4
    Hi Everybody
    I have the redtouch 6' cable, it looks stiff , but i'm trying to figure out if it's possible to use red touch as monitor for the operator, so using that wire, making it pass near the motor cable (that anyway are softer) or just leaves it free. Do anyone have some ideas on which could be the best solution?
    I will test in these days and then post my experience.
    Thanks in advance for any suggestion and shared experience!
    best
    Arturo
     
  2. Mark Pugh

    Mark Pugh New Member

    Joined:
    Jun 30, 2013
    Messages:
    23
    Likes Received:
    3
    I've been using the 18" braided cables straight up from the camera to the handle, via a little twist in the cable. Works fine.
     
  3. Arturo Bernardi

    Joined:
    Aug 24, 2013
    Messages:
    50
    Likes Received:
    4
    Thanks Mark, i'm trying the "straight" conf, it seems that weigh the tilt motor of a 10%! not bad!
     

Share This Page