Dudes: We were filming in a helicopter today and everything was working fine. We landed, then about 2 hours later, went to boot up, and we just get the 3 flashing lights constant. We then: -Changed the already full battery to another full battery -unplugged all cables and replugged in -started in dead mode with DX8 controller on We need to use it, since we rented these helicopters for $20k and have no movi to get the shot. Some please help, cheers Chris cj@fkyskycandy.com 435-232-3633
Ouch. Best thing to do is email support@freeflysystems.com and open up a ticket. Can you confirm that the MōVI is absolutely still when you power it on, please? Andy
I've alerted the folks at FF (I'm just a volunteer moderator) that you're having issues. Hopefully someone can respond. But do email -- just to open up a ticket. What time zone are you in? Andy.
Andy thanks so much, I did already email them. It's a huge movi fail lol... Especially since we baby this thing and it's not working when we got the $ involved. I'm sure they will help out, they have been so helpful thus far.
Hi Chris, did you try to reset the settings? I don't have a clue if that could help, but... Don't know if you can access the MoVI with the GUI with three flashing lights though.