Movi receiver with PPM or PWM output to run other gimbals?

Discussion in 'MōVI Controller' started by Jonathan Jelkin, Dec 3, 2016.

  1. Jonathan Jelkin

    Jonathan Jelkin New Member

    Joined:
    Dec 2, 2016
    Messages:
    3
    Likes Received:
    1
    We'd like to use the movi controller to run a custom gimbal and camera controls. Our gimbal can accept PWM or PPM input. Can the movi receiver output PPM or PWM signals? Or can a different receiver be connected to the movi controller that will let us have PWM or PPM output?
     
    #1 Jonathan Jelkin, Dec 3, 2016
    Last edited: Dec 3, 2016
  2. Andy Johnson-Laird

    Andy Johnson-Laird Administrator
    Staff Member

    Joined:
    Jul 31, 2012
    Messages:
    10,383
    Likes Received:
    1,164
    That's a good question Jonathan.
    I don't think any forum members have actually tried to do that and posted the results...

    Andy
     
  3. Michael McVay

    Michael McVay Active Member

    Joined:
    Dec 31, 2012
    Messages:
    416
    Likes Received:
    91
    Not sure about the physical connection either - doesn't the movi controller receiver output primarily through the 5 pin cable? I know Quadrocopter made a little PCB at one point that plugged into the 3 pin spectrum satellite port and they got the camera start and stop signal out of that - maybe all the channels come through there as well - never tried that. Good idea.
     
  4. Dave Ketelhut

    Dave Ketelhut Member

    Joined:
    Jan 17, 2014
    Messages:
    35
    Likes Received:
    1
    has anyone had any success with this? I am looking to integrate the Movi Controller to our Ronin 2.
     

Share This Page