Movi Pro Timelapse Mode Problems

Discussion in 'MōVI Pro' started by Mitch Fraser, Jul 10, 2018.

  1. Mitch Fraser

    Mitch Fraser New Member

    Joined:
    Jul 6, 2018
    Messages:
    1
    Likes Received:
    0
    Hey all,

    I'm a new Movi Pro owner. While I love it as a 3 axis gimbal and it has yet to let me down, I am having some frustrations with the timelapse mode. Here's what I am doing and then what is going wrong:

    1) I put the Movi on a Toad mounted to a Ninja Star that is attached to my tripod
    2) I balance the camera the best I can
    3) I autotune at 70
    4) I open the timelapse page on the app, I set up my frame rate, interval and desired length
    5) I move the gimbal to its two locations (start and end point)
    6) I hit preview and it does the sped up version of the move, going from point a to point b
    7) I hit start

    Now when I preview the move it does it perfectly, it goes from the start point and stops at the end point. However, when I hit start, it starts at the start point but then keeps going far past the end point and moving faster than it should be based on the timelapse parameters. Am I missing something here, what am I doing wrong?

    Movi Pro firmware is v1.4.3 , app is v1.4.1
    Running a Canon 5D Mark IV with a Canon 16-35mm f/4L IS
     

Share This Page