/dist/images/branding/favicon

motors not cogging properly?

Discussion in '3 Axis Gimbal' started by Laurence Hamilton-Baillie, Aug 21, 2015.

  1. Laurence Hamilton-Baillie

    Joined:
    May 23, 2013
    Messages:
    67
    Likes Received:
    6


    Hello. hope the link works. I don't think the motors on my gimbal are cogging properly. (alexmos 32bit board) they have very little torque, and when i move them they have very many small cogging clicks instead of big ones. The motors don't react to a change in power, reverse direction or number of poles in the gui. Anyone know what might be going wrong here?
    Thanks
     
  2. Dave King

    Dave King Well-Known Member

    Joined:
    Dec 24, 2012
    Messages:
    2,712
    Likes Received:
    311
    What motors? What are you settings for each motor you have setup? How many poles do you have specified for each motor?
     

Share This Page