M5 / DJI S1000 Setup - Help

Discussion in 'MōVI M5' started by Chris Benny, Jun 21, 2015.

  1. Chris Benny

    Chris Benny New Member

    Joined:
    May 31, 2015
    Messages:
    19
    Likes Received:
    3
    Hi everyone.

    I have recently mounted my M5 onto my DJI S1000 with the Koperworx adaptor plate.
    I tested out the gimbal yesterday and found it pretty smooth - but this morning in a little wind, the footage is all over the place.

    I was hoping you could review the footage below and give me any pointers. Any help would be much appreciated. :)

    The S1000 is flying very smooth with balanced props.
    I am flying a Sony A7s and have added some weights on the base plate as I found it was a little too light on the Tilt axis.

    Here are my settings on the Movi M5:

    Pan Stiffness: 104
    Roll Stiffness: 69
    Tilt Stiffness: 23
    Auto Tune Percentage: 70

    Expert;

    Gyro Filter: 2
    Output Filter: 1



    Any help would be hugely appreciated!
     
  2. Cam Batten

    Cam Batten Member

    Joined:
    Jun 10, 2013
    Messages:
    103
    Likes Received:
    4
    Chris, I would take your Gyro Filter and Output filter up to 2, 3 respectively. What lens are you flying? I find using a slightly heavier lens, like the canon 16-35, gives better results. Others here don't have a problem with lighter lenses and may have better intel for you
     

Share This Page