Lens calibration comes up short

Discussion in 'WEDGE' started by AdamSculthorp, Jan 25, 2016.

  1. AdamSculthorp

    AdamSculthorp New Member

    Joined:
    Mar 17, 2013
    Messages:
    15
    Likes Received:
    2
    We're having an issue when calibrating lenses, using Heden motors.

    The Wedge starts calibration, the focus motor hits both end-stops (full range calibrated) however once the calibration is completed we never hit infinity. Limits are all OFF.

    Anybody else experiencing this?
     
  2. Harry Mustermann

    Harry Mustermann New Member

    Joined:
    Dec 10, 2015
    Messages:
    20
    Likes Received:
    3
    Hi Adam, we are experiencing similar problems. It calibrates fine, but in the end it misses the end point by a minimal percentage. Don´t know why this happens. ...
     

Share This Page