How to loosen the horizontal Gimbal bar?

Discussion in 'Camera Mount Misc' started by Morgan Friedland, Sep 6, 2012.

  1. Morgan Friedland

    Joined:
    Aug 24, 2012
    Messages:
    84
    Likes Received:
    9
    In order to balance our camera on the gimbal, I need to slide the horizontal bar that acts as the Roll Axis. There are 2 clamps that seem to be holding it very tight. I have loosened them but the clamps do not seem to release do to tension applied by the plate that contains the gears it spins on. I did try loosening the 3 small screws that secure the bearings to no avail.

    Is there anything else one must do to get it to release?
     
  2. Morgan Friedland

    Joined:
    Aug 24, 2012
    Messages:
    84
    Likes Received:
    9
    Never mind. I was turning the wrong side!
     

Share This Page