Dual S.BUS2 Telemetry

Discussion in 'ALTA' started by Mikkis Youngblood, Jan 16, 2016.

  1. Mikkis Youngblood

    Mikkis Youngblood New Member

    Joined:
    Jan 16, 2016
    Messages:
    8
    Likes Received:
    0
    Just finished reading all the manuals as well as building the Freefly ALTA. All is good and ALTA will arm as well as boot with no errors. Can't wait to make some test flights tomorrow.

    I set up the dual R7008SB using S.BUS2 but aren't getting any telemetry in my 14SG controller. Everything was preset in the factory. Wondering how I could go on debugging this? Didn't find any info by searching online.

    One thing I have yet to test since still inside... will the telemetry show only when you start all motors?

    Thanks in advance!
     
  2. Adam Orens

    Adam Orens Member

    Joined:
    Oct 7, 2015
    Messages:
    60
    Likes Received:
    3
    Have u looked on YouTube? Lots of tutorials on the way to set up telemetry.
     
  3. Mikkis Youngblood

    Mikkis Youngblood New Member

    Joined:
    Jan 16, 2016
    Messages:
    8
    Likes Received:
    0
    Actually just got it working. Just needed to do the binding again for some reason.
     
  4. Gary Haynes

    Gary Haynes Administrator
    Staff Member

    Joined:
    Jul 6, 2012
    Messages:
    5,211
    Likes Received:
    460

Share This Page