/dist/images/branding/favicon

Dimension

Discussion in '3 Axis Gimbal' started by Peter Daubner, May 13, 2013.

  1. Peter Daubner

    Peter Daubner New Member

    Joined:
    Apr 15, 2013
    Messages:
    3
    Likes Received:
    0
    Hi,
    Could anyone clarify the distance in the picture?
    Mainly I needed distance from the center of gravity of the camera to the base for attaching the camera, as it is in the picture .....
    Thank you in advance.
    Peter
    vzdialenosť od taziska.jpg
     
  2. Gary Haynes

    Gary Haynes Administrator
    Staff Member

    Joined:
    Jul 6, 2012
    Messages:
    5,211
    Likes Received:
    460
    Peter there is no single answer to your question. CG has many factors. Changing a lens will change the CG. Adding connectors or a battery will change the CG. Only way to get the CG is trial and error while that particular camera is mounted to the gimbal whether the mounting plate is on top or on the bottom.
     
  3. Peter Daubner

    Peter Daubner New Member

    Joined:
    Apr 15, 2013
    Messages:
    3
    Likes Received:
    0
    Hi Gary,
    Thank you for your answer, of course, is clear to me that the balance should be based on specific factor Or sufficient size + guide me - this is not a precise measure.
    I will be grateful for kokrétne approximate distance.
    Thank you very much

    Peter
     
  4. Gary Haynes

    Gary Haynes Administrator
    Staff Member

    Joined:
    Jul 6, 2012
    Messages:
    5,211
    Likes Received:
    460
    Tubes are 200mm for the cross bars and side bars (cross are standard with the gimbal you would need to buy the longer bars for the sides). You may also find, depending on the height of the camera that you need to purchase a longer tube for the drop. The standard is 125mm. Folks flying RED's have probably replaced their drop tubes but I don't know what length was required to get height clearance. Your QC dealer would probably know what has been ordered or someone on the forum may be able to help.

    Adjustable tilt bars are 150mm in length.

    If you need a wider camera buy longer cross tubes.
     
  5. Peter Daubner

    Peter Daubner New Member

    Joined:
    Apr 15, 2013
    Messages:
    3
    Likes Received:
    0
    Hi Gary,

    Thank you very much for the comprehensive and quick response

    Peter
     

Share This Page