Hi everyone, Found this thread just when I finished my "upgrade" of vibration dampening. My problem was that I got high frequency "sequenses", i.e. happened every now and then, not all the time. For me it seemed that the body of the dampener could touch the frame (reading the previous posts, I realise that the heat from the esc's could be affecting). My solution was to add small vibration dampening gel pad sinside the O-rings and increased the height of the standoffs by adding a 10mm aluminium tube as a spacer. See the pictures: At the same time I'm looking for a solution to attach a Ronin-M under my CS8. Adding an extra plate under the center could help and at the same time give a possibility move the dampeners there. Found a quite good selection of standoffs here: http://www.famoushobby.com/Wholesale-Discount-spacer-aluminum-spacerstandoffs_c394.html