Hello, I wanted to see if anyone has poked around in the software on the Controller and M Movi's? We are looking at converting our M15 and Controller from 2.4GHz to UHF. I know a few people have swapped out the X-Bee Wifi PCB to the lower frequency X-Bee board. Which I believe required dumping the software off the old board onto a computer then uploading it to the new board. Is there anyone still on here that has done this and what did you learn from doing it? We wanted to know how the different software in the gimbal processor and the RF board process the data, what protocols are needed/used. All to help us understand how we can better integrate a UHF transmitter to improve the terrible wifi frequencies. I know the Movi Pro has the API and I'm sure we could work it out from that if the M range had an API too, but it doesn't.