/dist/images/branding/favicon

Camera Controls via Radians

Discussion in 'Radian' started by Chris J Ayres, Aug 12, 2013.

  1. Chris J Ayres

    Chris J Ayres Member

    Joined:
    Jul 28, 2013
    Messages:
    41
    Likes Received:
    0
    Hi,

    I have my CX730 connected to both the roll and tilt radians. The roll radian has the zoom control and the other the shutter control. I have each Radians AUX channel assigned to the control on my DX8 TX. Both work fine and control the camera but.......when in slew mode and the camera 3 pos switch is positioned to record video, the tilt radian radio signal cuts in and out intermittently. What I mean is the yellow light on the radian goes out and the tilt access effectively centres itself and behaves as if in stable mode (pos 1), O being off and 2 being slew.

    Any help on this appreciated.

    Chris.
     
  2. Chris J Ayres

    Chris J Ayres Member

    Joined:
    Jul 28, 2013
    Messages:
    41
    Likes Received:
    0
    May have sorted this out. Looks like the travel on the AUX2 channel for the 3 pos switch were too high at 118% each direction. Lowered the setting to 100% and no more tilt TX interference. I remembered this as the PAN servo travel has to be as low as 80% to prevent some kind of TX interference.
     

Share This Page