Separate names with a comma.
Discussion in '3 Axis Gimbal' started by Andy Johnson-Laird, Aug 16, 2012.
There's an A/V cable that comes in the box with the 5D Mark III. Use the yellow plug.
Oh, he said, faintly, "That one?"
I thought it was some other special cable!
De Cinestar 3 mount is ready
Thought I share you guys some pictures
Total weight with the Sony 730
The total picture
Except for the lipo all wiring insite
Mario as i see you are tighten up the radians with tireups ...! is this better for vibes ??
Only the tape I find that a bit risky with all the cables pushing and pulling the Radian's, if one get loose...............
Vibes? what is that
Ηaahahah you Have the Flexa??
Beter, we make them
This is the one that will be lifting the CS3 mount.
WOW! Thats interesting looking! Also looks heavy!
All plusses gomez with some minors
Lots of power
For perfection, go get the dual bearing on the right tilt arm.
I have it on both my 360 gimbals and it makes the tilt even smoother
For heavy cameras it is a must I think!
In time we will make one Janne
For now with the 730 I see no problem.
what gains do you achieve on the pan axis with the cx760 on it?
if i go higher than 50% the gimbal starts to oscillate.
Genneally i have 40-50...!!
Still no numbers here, working hard to get my Kratos airborne.
We did some first tests today. But the result looked not that good.
First part is inside and already here you can notice some vibration.
It was windy outside and you can clearly see the vibration. It seems like the wind catches the gimbal. Also if i tap on the gimbal it oscillates a bit.
But not because of the radian gains. the red dampers let the gimbal oscillate. If i remember me correctly we only.have 3 of them installed. It's not me who assembled it. Therefore i am not sure. Have to check that.
Boss stabilization on the cx730 was set to off.
at 1:30 it's stabilization only. no gimbal movement.
Put the radians off and fly again to check it..! it seems that there is some vibe an overcorrection of Radians..!
And the gain of the Controller seems a little high.>!
we put off the radians and we still got vibration. i also have to say that it is very cold here. -10 degrees.
The RVS wiredampers we use have no temp limitations, they work from extreme hot to extreme cold without adjusting