Alta and compas errors

Discussion in 'ALTA' started by Ricardo Perret, Jan 19, 2017.

  1. Ricardo Perret

    Joined:
    Oct 22, 2015
    Messages:
    46
    Likes Received:
    4
    Hello at some places my alta does not start, these are on places like interiors and places with a lot iron in the ground. It is clear to me that such an underground and environment is not perfect to start a drone, but sometimes there is no other option. When i booth the Alta outside the building or on a iron free place than its not a problem to move the drone and start after in the same bad environment.... is there any trick, settings how i can handle this problem?

    Best Regards

    Ricardo
     
  2. Jason Smoker

    Jason Smoker Active Member

    Joined:
    Oct 23, 2012
    Messages:
    840
    Likes Received:
    67
    i wondered about this, I fly in construction fields with big iron board plates, but with mk flight board. With the Mk you just turn off the compass effect and its good to go.

    Did you send a email to support?
     
  3. Ricardo Perret

    Joined:
    Oct 22, 2015
    Messages:
    46
    Likes Received:
    4
    Hello Jason i have a few cinestar 8 with MK electronic and right, there is no problem...
     
  4. alex ryan

    alex ryan Member

    Joined:
    May 8, 2015
    Messages:
    227
    Likes Received:
    16
    maybe you could try motion booting?
     
  5. Humberto Barchini

    Joined:
    Oct 31, 2012
    Messages:
    94
    Likes Received:
    26

Share This Page