/dist/images/branding/favicon
Separate names with a comma.
Here is some more info: During the slalom race of the FIS Alpine Ski World Cup in Madonna di Campiglio/Italy in the evening of 22 December 2015,...
Yep you are right, typo on my side, of course it's the gyros!
With MK you calibrate every time before motor start. That was a problem on a boat as it moves around and the acc couldn't calibrate. With boat...
Have you tuned the dynamic stability? [media] Not sure, but maybe that helps?
Yes you can simulate a receiver failure with your Rx. It's the fail safe channel in Mk tool. Change that to the poti you require and you are done....
Andy, I think you meant the right thing, but 'ignore compass error' should actually be unchecked, as you do not want to ignore compass errors at...
I think you emergency gas is at 65% a bit on the low side.( = 65% of hover throttle! the copter will fall straight out of the sky) I'd also set...
Sorry to hear about your crash Steve. I found a high powered led system very helpful to keep orientation. The led strips are pretty average....
I wonder if there is a deeper problem behind that. I know of at least 3 copters with unexplained yaw issues. A Cinestar 8, Cinestar 8 HL with U5...
Totally agree, another 7 bullet connectors per arm is a no go for me too. We had a large octo and a hex. Octo was then set up without bullets with...
I would guess as well that you forgot to tick 'use various control for failsafe' so it used 90 stick settings instead of 90% of hover gas ( or...
Problem is only that to my knowledge the UHF is illegal in Austrailia for controll purposes.. So it's not rally an option for a commercial setup...
I work as a Firefighter. Our current standing orders are to extinguish LiPo fire with water or co2. Reason for that is what is called 'thermal...
Sorry for your crash. It also pays to check fail safe. You can actually put it on a switch and simulate switching the remote off, without...
I might try to get some 16" and try that.. Any other ideas? Thanks for your reply Steve(:-)
Firmware is 1.08c It happens in manual and AH/ GPS.
Hello everyone. We got a CS 8 in x8 configuration with MK 2.5 MK double quad 3.5 Kde 4012 motors 17" props. With 16000mAh battery and a 2kg camera...
Once we found out the settings / mapping for the mode switch it went ok from there. Still some turning to do, but functions are there. No lag here..
Well, we have troubles as well. Using an mx 20/ GR 16. Connected, Sumo and stuff set. Is there anywhere a description for the different channels/...
Maybe the Pirate Eye is your solution? http://www.payatechnology.com/Features.asp?id=4