/dist/images/branding/favicon
Separate names with a comma.
Saw this today, and thought it may be important. I've not seen any discussion about it, but I think the "active braking" pushes current back to...
Graupner USA www.graupnerusa.com [IMG] 2349 miles from you in United States, CA, San Diego Joined Oct 2013 1,248 Posts Dtd: 6-1-20015 It fixes a...
Replaced the Tiger motor connectors with these RC PROPLUS bullets from AMAIN hobbies Not sure how long the supply will last, looks like they are...
FYI: New software 2.10 http://wiki.mikrokopter.de/en/Firmware-2.10 Most Important Change: ACC-Calibration [IMG] Note: the 'normal' (old)...
I bought a Navi 2.0 and an External Compass from QC a while back. The last Navi I upgraded had a very small surface mount chip, similar to the...
"Except as otherwise provided in this section, no person, entity, or State agency shall use an unmanned aircraft system to do any of the...
After seeing Tim's post I'd like to express to MK that perhaps it is time to simplify your user interface and setup! I really feel bad for Tim....
If you have a recently purchased Graupner Receiver, or upgraded your Rx firmware, the signal loss Failsafe does NOT function without changes to...
I had my External compass mounted on top the GPS, with two small extenders. I thought it looked exposed so I mounted it to the front Arm of my...
MK does NOT go into failsafe with loss of signal with latest Rx updates, and new Rx (GR-24L ver 3.76 and 3.78) GR-32...
MX-20 GR-24 CS6 and MK Qaud I have two problems: No loss of signal FailSafe on the CS6 and BOTH Rx (two are on the same channel?? ) Was updating...
Another update for PH! "Higher accuracy on Position Hold The accuracy of PH is much higher now and the position is faster reached if the MK...
I just got a new GR-24 and bound it, connected it all up. I then went to set up the "SUMO 12". It just would not go to the right screen, the...
I've been waiting patiently for the ACC MK upgrade to come back in stock. Now it is not even listed. "When we started selling the v2.5 FC, we...
This look like new option to put the BL-Ctrl out on the arms, perhaps keep them cooler. Maybe even shrink tube them for protection? It has 8...
FYI: When you update the MX-20 firmware it saves all your "Model" info, you don't lose it. I also put in a new Rx, and did a "bind", my Radians...
I finally hooked up my Smart OSD to my new 2.5 FC, and running v2.02a I noticed my compass headings were allover the place, showing about 20...
Thanks for all the help, given so unselfishly! Hope you have fun, peace and crashless flying over the next year!
Well we didn't make it to 2.01z as many of you predicted..lol Merry Christmas! http://www.mikrokopter.de/ucwiki/en/Firmware-2.02 Support for BL V3...
Just a "heads up". I was thinking of replacing all my prop mounts on my motors. I've had the props on and off so many times the tops are getting a...