Separate names with a comma.
Can some one please take a look at this and let me know your thoughts. I'm thinking the shaking is caused by the dampers being too stiff? What do...
Thanks Guys, just refreshing my memory on Mikrokopter. My readings were pretty equal, 58 68 79. Just upgraded to MK 2.10 from 2.06 and also moved...
What should Magnet Inclination read? I did a quick search and couldn't see much about it. Cheers
Can the ACC leveling be done with out a wireless set up. Eg. if I notice drift to the left, land and then adjust the settings in MK tools to trim it.
Just had a brain wave. I work for a fishing show, so were always beach launching and flying out to the boat. The landing pad is large and weighted...
Ive been on a few jobs where my machine has lost compass calibration while sitting in one spot waiting for the action to start. When it happens...
Im using a slipping on a 3axis converted to alexmos gimbal. works great.
I have a Skyjib x8 with 15" props, and mk 2.08, same issue, AH isn't very good. Ive spent hours tuning it.
16 sats would have a noticeable impact on how accurate gps hold is wouldn't it? Im normally seeing 8-10 here in NZ.
I'm using kw10s with soar 15x5 and 16x5 on my x8, only at the 9.2kg mark but I'm getting 12min with 9000 6s. Im hovering just over 50% throttle.
Are there any images of the 2x Quadro Xl boards? Im running the QuadroXL, and its been great.
I have re-contaced support and I'm going to RMA the board. But il have to ship it back from NZ, so it will take a while I'm guessing. Does any...
Would you suggest i pull off the foam and try this method even though its a 2.5 board? Also do you have a photo of it?
Dave can you plug yours into the computer and just have a quick watch for me; to check how much your numbers move around? Il contact support again...
Hi thats what i had done in the past, i tested it again with out the heat shrink that was clearly causing a few issues. It still moves around a...
I was just meaning since you assign it to a profile, maybe changes are needed other than setting it to follow mode. I tried it along time ago and...
Are PIDs different for the follow mode?
When doing a compass calibration, is it vital that when flipping the multi rotor it stays pouting exactly north? Does it make a noticeable...
So check with a real compass vs a my phone?
Yea its the compass calibration, error, calibration. Which im having to do each day. I think i may have worked out what happened. I calibrated in...