Separate names with a comma.
SOLD Selling my Alta X setup, will consider parting it out. Alta X, Case SOLD- XM2 Landing gear (used on 1 shoot) 24 11000 6S batterys (6...
Hey Guys! Anyone every flown the F55? I'm shooting on the F55 in Raw mode and I'd like to setup a remote setup so we don't burn through card...
Finished up a 4 day shoot at the dunes. Was super careful but still managed to get my tilt motor full of sand. ( hear grinding when I turn tilt...
Finished up a 4 day shoots at the dunes. Was super careful but still managed to get my tilt motor full of sand. ( hear grinding when I turn tilt...
So I came to Peru 5 months ago with my UAV. No issues. Came back again and customs said that a new law was past 3 weeks ago saying that...
Hey Guys! Love my M5 but i've had some issues. When flying after landing it seems like the pan motor shuts off, I take off again and I have no...
Did an autotune and when I initialize the gimbal it flips up side down with the sensor on the top bar and the camera faces the rear. Any...
Hey Guys, Trying out the Superx on my U7 heavy lifter. Anyone here fly a heavylift using SUPERX, can you tell me your gains? I've tried out all...
Hey Guys, I have/had a big shoot in San Francisco, a section of street is going to be closed off and people are going to slip n slide down the...
The specs on this thing are awesome. Pre-ordered in February, and it finally came. It's worthless to me if I can't use it as a stand alone....
I made a little video about the experience. [media]
Tried downgrading to 5.16 on my wookong, U7, castle 75amp octo x rig . When I start up the motors The right front top and bottom motors wig out...
These motors seem to be a hot item! Anyone know where to get them? Even China! I've got a 2 week shoot leaving march 3rd and need 4 U7 490kv's....
So.. I've have 2 random experiences with my wookong in cold weather. The first was in Mammoth Cali. I went for my 3rd or 4th flight came down...
I have a 2 week iceland shoot, but the client heard that the wind is crazy and difficult to get rc aerials. I've seen video from local iceland rc...
I'm changing motors on my second cinestar, do I need to re-throttle calibrate the esc's? Or should the first throttle calibration still be good?...
[media]
So I built a heavy lift. wookong, cinestar frame, axi 4120/14, 15inch xoars I did test with a 8lb dumbbell as payload. I flew 2 5S 8000mah...
Hey Guys. I built a HL cinestar DJI octo X. I took it for a maiden flight tonight. Took off in GPS mode, flew great for about 1 minute, flipped...
I think it would be amazing to have a flight simulator that I could hand off to potential camera operators and have them learn the basics and get...