Separate names with a comma.
You are the man! Thank you.
Hey guys, thank you for taking a look at all this, I really appreciate it. Sounds like I have some careful scoping to do, will report back with...
Well it was only a matter of time, had my first two real crashes happen the past two days. The first one was my fault, I had just finished putting...
Anyone have input on the octo vs octo2 setup? And my lighting idea listed above?
#2 is one of the reasons I was thinking about switching to an "octo" setup for filming. My other gripe with the "octo2" setup is the Y...
Yep, bad cable...problem solved!!
Yes I wondered about that as well...most of the time it is solid, but others it flashes and does let me fly... Thinking its the 6 pin ribbon...
I'm assuming the reason my compass is not calibrating is due to the fact that the FC is not communicating my transmitter inputs to the...
I'm having the same issue discussed here http://forum.freeflysystems.com/index.php?threads/error-3-the-nc-has-no-communication-with-the-fc.1716/
Sorry, copter is already facing north. Been following that video, yes.
Andy, I've got this all reconfigured properly and GPS shield soldered on. I'm getting around 7-8 satellites consistently so I know it's working....
Hilarious. Yes, these bullet connectors need to go. Have had the bird in the air for a few hours so far. Lots of tweaking to do, but damn is this...
Yes, about those wires....we're in temporary mode, as the EC5's I bought did not fit the massage 8awg wires of these zippy's. I need to order some...
Soldered GPS shield on, now I'm getting interference with the satellite receiver which will not power on with the GPS connected. They are side by...
I'll change this to the proper Y pattern with the red lights up front, but for now this is going to have to work.
On post 29, we're looking directly to the back of the heli. Yes, I haven't found anyone else flying with the cinestar in this orientation. As I...
Thanks Dave...I was thinking the same thing. So, I can still use this plate, but mount the batteries flat side by side, perpendicular to the way...
And yes, I realize the red stripe on the ribbon cables are opposite as to what Andy shows in his "Rather Good Guide to MK Tool", but it only works...
[media]
Sounds like the batteries may be the issue. Thanks for the heads up on my incorrect mounting Steve and Dave, I've now stacked them side by side,...