/dist/images/branding/favicon
Separate names with a comma.
I was finally able to get a flight in, and didn't see any measurable pan drift, so I think Andy is correct in that it doesn't do it in flight.
I'm just waiting for a calm day to test it out while in flight, just as Andy suggested. But on the bench it still does it.
Here is a screenshot of my pan radian. Also, Andy I will test it out in an actual flight and see if it still does it. I checked my transmitter...
Here is a quick video I did. Sorry about the audio (don't know what happened there). As you can see in the video, when I turn on stabilized slew...
I checked that and it was centered.
The Pan on my gimbal rotates very slowly without any input from my DX8. When I plug the radian into the software it doesn't show the current angle...
Hey Guys Thank You very much. I never did think about the potential for misalignment. I did exactly what you said and it works fine now. I hope...
I was playing around with my 360 Gimbal and noticed that there seems to be some friction in the bearings for my tilt. I took the belt off to...
Andy and Alex thanks for the quick replies. All of the I2C errors occur at startup and they do not increase during the flight. However, I will go...
I had a weird landing with my copter where one of the legs got stuck in the ground and broke off. It wasn't really a rough landing, but ever since...
Thanks Brad, I just looked at it, and my tilt is actually in port 4. I must have got my numbers confused. Thanks for the help. I am all set to go now.
Hey Guys, I figured out my issue. I didn't realize that I needed to plug the usb programmer into each radian. I thought it just needed to be...
Aircraft Type: Cinestar 8 Gimbal Type: Freefly 3-axis Radian Type ( 1, 2 , 3 axis) 3 axis Gimbal Power source: 1350mAh 11.1V with Castle BEC...
Arthur, Thanks so much, that makes complete sense to me. I can't wait to start using this thing.
Hey guys, I am new to the whole wiring and electronics thing. I just purchased a 360 Gimbal (without Radian) and am trying to figure out how to...