Separate names with a comma.
I just want it gone. Its cost me way too much already. CS8 HL with MK electronics (kit by Quadrocopter; assembled by me) 2x Pelican cases 4x...
I'm getting out of MR flying. So everything must go. I'd like to get rid of everything in one bundle, but I'll break it up if I have to. Asking...
I've got a CS8 HL w/ gimbal and video downlink available for work in Alaska. I'm willing to rent it to an experienced pilot, or fly it myself....
I have read many times on this forum that a crash could have been avoided if the pre-flight checklist had not been rushed and/or skipped. So I'm...
So on a on a Cinestar 3-Axis + 3x radians I would like to set up the tilt axis to be controlled by the throttle stick on the camera controller....
Good evening everyone! I just finished my CS8 Heavy Lift from QC build recently (MK stack). I decided to do a couple test flights in a bare...
A couple weeks ago I had my FlightCtl 2.5 on the bench for first time programming. I ran across a setting that changed the default motor start...
So Page 19 of the MC-32 transmitter manual reads: Both the left and the right joystick can be configured for neutralized or non-neutralized...
I stumbled across EMI-shielding heat-shrink today. Thought I'd share. http://www.wirecare.com/product.asp?pn=WC02769229 I emailed the wire care...
I've got a 3-axis Cinestar gimbal with Radians - servo driven. Will the toad in the hole quick release work with this? Will I need any...
So, I'm new to battery math. Please point out my mistakes. I've got a 10,000 mAh 6S 25C lipo. My motors are 8x MT4012 480KV. If I understand...
Hello all! So I'm trying to check out the MK FC 2.5 in KopterTool. I hooked the FC up to the MKUSB and KopterTool talks to it just fine. I...
So Quadrocopter sells the eFuel 1200 power supply. Anyone have any idea if this can be used for more than just powering the battery charger?...
So I don't know if this is the correct forum or not. And I am certainly not interested in "getting anyone in trouble". But eventually the FAA is...
I recently purchased a CS8 heavy lift kit. It came with the MK Quadro XL PDB/ESC board. To my eyes, the holes in it don't appear to align with...