Separate names with a comma.
From T-Motor We suggest the setting is low timing, below 15 degree. PWM is 8Khz or 12Khz. You can test the setting on bench and then flight....
Hi Bryan, It's hovering with around 57% throttle in no wind
Gary, there were a few Herc2 boards burnt up in flight.......This is going back a few years now and looking back the motors then were a lot more...
Hi Michael, Yes the Herc3 has those features and is probably the most advanced powerboard available at this time and it's 6S capable (there is an...
Hey Dave, I'm running MK electronics with a Herc3 board on 6S, coaxial X8 with 18" carbon props and MC-20 Tx. So far it is performing very well....
I can't see why anyone would want to drop an Eagle from height......??
Thanks for the figures Kari, did you run the numbers with 2 blade 18 x 7.6 carbon props?? Regards, Lance
Hi Howard, AUW is around 15kgs when testing. I'm using MK FC2.5 and Herc III Throttle stick is just over 1/2 and drawing 97 Amps on the MC-20...
Thanks for the replies. I bought a set of KDE-Direct 4014 motors and have just bolted them on and have had a couple of brief test flights. No...
What options are there for a replacement for the U7 and what has been tried and tested......Results anyone?? Thanks. Lance
Theo I agree with Howard it sounds like you have the screeching sound coming from your motors too
My motors are the U7 420Kv and I'm running 18x6 carbon props. I'm using MK flight control and not getting any issues with vibrations......Just...
Thanks Howard......What was the outcome when you emailed them??
I have just test flown with 8 x U7 motors and have a screeching noise at 40% throttle setting whilst hovering. It's not a mechanical noise and is...