Separate names with a comma.
https://www.facebook.com/cbcnews/videos/10153729011224604/?fref=nf
Hello everyone , I am returning to my CS6 settings and I'm in doubt about landing speed for failsafe, the default setting is 12, this is 1.2 m per...
Hello, I'm currently flying with the firm 0.90, by an incident, (lost signal, happily without consequences more than a scare, ) I am thinking to...
Hello, someone used these batteries?,...
Hello, which is the most secure, stable and with great autonomy to fly inside stadiums ?
Hello, I review threads here and mikrokopter web and I still not I have clear what I has to change for use 6s in FC, mikrokopter web site says...
Hello, What values most important that we have to keep in mind when viewing some configurations in Ecalc, I know that all be important but...
Hello guys, I appeal on his vast experience for a suggestion and advice, I'll do an update of my cinestar 6 to a heavy lift , I want to continue...
Hello, In my gpxtool when I want to see the graph of motor current I can only see four motors, is program configuration or something else, any...
Hello, in mktools, the figure 3D must be perfectly still, if the cinestar is in the bench test ? Gustavo. [media]
Hello, What advantages I can have if I make update to 5s or 6s batteries without changing the standard configuration of a cinestar 6 ?, ie...
Hello, I think make flights over 1500 masl. and more, which firmware I need for this, I have a spektrum Dx8 and Fc 2.1 with 0.90j and Acc...
Member of this forum. [media]
Hi all, My problem, I have error # 10 after two flights without incident, I have a steady red light in NC. I have reviewed the welding Acc...
[media]
Hello, Is possible, having the height control enabled ,keep the height with other channel we want without need to place the stick in neutral...
Hello, After updating the FC with the Acc board and the firmware 0.90j, I have an error, "Error 5: No GPS Communication" any idea what may be...
Hi, Checking my PDB to see if there were any loose capacitor or anything else that causes I have high consumption , I found that I have in...
Hi, I have a Spektrum dx5e radio that controls the tilt and pan of my gimbal using a AR8000 receiver, question, it is possible that with a...