/dist/images/branding/favicon
Separate names with a comma.
Thank you for your answers. I am currently 'WooKong-M' is in use. Changes in the movement for the MK setting above figures, so I'll know. And,...
Answer a lot of late. Above, as we did many tests. Exactly align the center of gravity, It was good timing belt tension. I do not, but it does...
Struggling with the same problem. Still is not resolved. T ^ T
Answer Thank you both. Bec output 5.5v, 6.0v, 6.8v, 7.4v. BEC 5V output to replace? Will a 6V enter a bad influence on the Radian? FF...
freefly servo, radian is in use. Voltage of 6V is using servo, I would like to replace the one Required voltage is 7.4V. freefly servo, radian...
What is the roll / tilt pulley gear ratio? f360-0866 servo and the radian is in use. 5d mark 3 using roll shake a little of but I can not do it...
Machining aluminum 5mm The middle scooped out the parts you do not need to 2mm, and is used to reduce weight.
Thank you your answer. Gave the contents could not be resolved. Systemfile of damage rather have to reinstall Windows XP. Is going well now....
[Setup cannot continue because some system files are out of date on your system. Click OK if you would like setup to update these files ofr you...
Was able to solve the problem thanks to Again, thank you so much .. ^ ^ go down the pan axis gain up to 30% It's stable. "
What kind of person are you? Radian programmer? Or Genius? If I accurately described could have easily solved. Like clumsy English, more...
And try again. 1 radian green led slow blink. Settings can not be changed situation therefore was not modified setting. Module is * Unknown * The...
Exactly what you mean, I did not understand, This means supposed like shooting video link. http://youtu.be/XSP0nQuEdwg It's too hard to talk...
give up... :(
Not modify the thing is. but only read and write... Anyway, I will not...
[ATTACH][ATTACH] [ATTACH] Every time you power on, off This value varies. The tilt axis position is fixed.
Do not know English, it is difficult to understand. You talking about the content of the below is correct? Currently using a satellite receiver...
Tilt. Servo, resistors, cable, etc. ... 've All changed are the same. Link to the video. [media]
Thank you. This problem has been fixed can not be saved. But I do not still green led blinks and initialization protocols. roll and pan will work...
Radian set to save all three of you can not. (Write-> timed out) One initialization failure of the lamp to work. "Green LED slow blink = Motor...