/dist/images/branding/favicon
Separate names with a comma.
Thanks for the info, Phillip... It helps to know others are experiencing similar issues, I was hoping there was something I was missing,...
Gary- Thanks for the response! We've done 1 and 2, that's how we verified that we had mostly eliminated the oscillation... Prior to that there...
Radian on a 3-axis cinestar gimbal, latest 1.03 firmware. Savox on pitch, FF servos on pan and roll. Camera balanced without belts on. We've had...
Sooo... After all that, I tried setting 1024 on the tilt unit (was doing it on Pan before) and it seemed to work immediately. So I must have been...
John- Yep, I definitely did... When 1024 was enabled I got basically no channel values, and the Spektrum Valid indicator never toggled on. So...
Thanks for the response! I've never used 1024, as I always get basically no "Spektrum Valid" connection and no values in the input monitor, as I...
Gary- The sticker inside the receiver on one says 7224, the other says TA807B. The latter is the satellite from an AR 7000, I believe the former...
So this may or may not be related to 1.03, but since no one else has reported it I thought I'd start a new thread... I updated the firmware on...
I haven't been able to get PPM working with mine at all... I tried a DIYDrones PPM board as my receiver doesn't have a PPM out, and I got the same...
Any chance your radio was commanding a roll to the radian? Did you check the slew indication on the roll module using the config software?
That's correct. I have my shutter on the Pan unit because it's a better wiring option, so I set up the Pan unit to output channel 6 on AUX. If I...
I don't believe the Radian acts as any kind of voltage regulator, so if you put in 12V it's going to pass that along to the servos, which you...
A better solution for this is to use the Aux output of the radian to control the shutter... Just connect the radian unit closest to your camera or...
Brad- Check out: http://forum.freeflysystems.com/index.php?threads/radian-stabilization-maximum-voltage.103/#post-743 John and Tabb discuss...
Daisuke- If you leave the pan stabilization on with the heli just sitting on the ground, it will eventually start to drift and spin. You can...
So after switching the BEC to 6v, it seems like I'm getting more torque out of my servos, and the deadband is a bit less of an issue. Still there...
As a follow-up to this, here's what you can do: Plug satellite into 8000 base. Bind the combined unit to the profile on your transmitter you...
After some more testing, it was definitely brownouts, as the battery had dropped below 5v. So, user error... With a new battery and the BEC...
I'm having some issues where one or more axes will reset in flight... During testing I can see the axis jerk, and then the green light starts...
I'm powering mine using a voltage regulator connected to the first channel on the pan unit, since it's not in use when you use a Spektrum...