/dist/images/branding/favicon
Separate names with a comma.
Gary,I agree 3.6v seems like the safe spot to run. Thanks for the help!
Steve, Just changed the Undervoltage settings in MK-Tool to 3.3 and ran a battery down. It went all the way to 3% before warning. Probably too...
Thanks Steve, Just checked the gpx file and there's nothing on the card. Not sure what's up with that either. I'm checking the mk setting now.
Steve, Thanks for the quick response. I am using MK tool and I'll check these settings. We've had several batteries on it and no bad cells....
Looking for help with the early warning voice system. We just recently upgraded firmware. Everything is working well but we get voice warnings...
Just a follow up: It was that easy. I am sure though that this is different in several ways than it was in Version 1 of the software. Wish they...
That could be it then. I'll calibrate it and see what happens. Hope its that easy. Thanks! Bob
We were having some problems with our flight controls so we upgraded the MK tools, FC and Nav software. After doing so I'm having a few problems...
Just tried out a new Radian and it worked perfectly. That's the second radian I've had go bad on me. Thanks for the advice Gary and Andy!
That's a good idea. I have an extra Radian module that I'll place in there for testing. I thinking at this point that it's the radian. Bob
Andy, I did have the Radian mode set to off. In the on position it acutates the servo when it flickers like that. So it's doing what it should...
All, As I turn the tilt control on the Graupner mx-20 (2-axis setup) all works fine for a while then the tilt starts acting erratically. I can...
Thats too bad. Have you looked at the Jeti DC-16 as a replacement? It looks like it's totally configurable and has stick end controls that could...
Andy, Any luck in finding a rotary knob for the sticks to control tilt? Bob
Gary, Thanks, I ran across that thread as well. It'll make operating in a one person configuration a bit harder. Any tips on how best to deal...
Phillippe and Gary, Good questions especially on the proportional control of the Tilt. Gary can you verify that there is no way to change the...
Thanks everyone. Going to work with the carefree and teachable carefree today. We've just not used it with our normal two operator setup, glad...
We have a Cinestar 8 with a Mikrokopter flight control board. We just finished building a small dji f450 for some gopro work and it's a great...
Sebastian, Thanks so much for taking the time to document all of this! I'm going to spend some time tomorrow and work my way through it. Thanks...
Sebastian, That would be great! Glad to hear that it's possible. We want to do it for the same reasons, one operator practice and for smaller...