/dist/images/branding/favicon
Separate names with a comma.
Thanks Andy for getting back to us, We got it going finally, it was a small connector at the back on the bottom of the CPU module. It was actually...
It almost looks as though its been slipped into neutral.
Also, this was built and tested on friday with the same camera setup, and worked fine. all we did was take it apart to transport in a pelican with...
On set right now trying to balance the rig with an epic, and we're getting no response from the tilt motor. Either with the camera on or off,...
Hey, I havn't had to run bnc up to the bars but I have done so with power, I used a very flexible cable, roughly made it two feet and Velcro tied...
Yeah backing down the pan gain does work, thanks! Just still wonder why it goes away once you touch one of the side arms, even with just a finger.
of and yes I did read the manual, it does say that the top handle is the worst point for the pan axis, I'm trying to figure out why?
So something weird happens. I set my gains so there is no oscillation while on the stand and holding the long bar. However when I pick it up by...