Separate names with a comma.
A few days ago I switched my flat 8 to an X8 using the exact same diagram/setup. If you can see all 8 T-Motor logos when looking down on the...
i just received 4 10000 mAh from foxtech with the same sort of packaging - kinda freaked me out at first....then i noticed the double shrink as...
This fellow decided to fly his bird dangerously close to an aircraft coming into YVR....not cool. [media]
I'm looking at picking up one of the Alexmos new 3-axis 32-bit basecam boards for use with GB 85 motors....
Do these exist for purchase somewhere? I've contacted Caravec several times but have yet to receive a reply.
Which I2C converter are you using? After two failed Double Quad 2XL boards I'd like to take this route but was always under the impression the I2C...
Hopefully the firmware update eradicates that Hindenburg bug - very scary and very dangerous.
It was around 28 C and slightly humid. The weeks prior I was in Bali where the humidity was often be in the 75 range and an air temp of 30 C....
So far my experience with the Double Quad 2XL ESC has not been a positive one. My first board barely made it past the first motor test before it...
Seems to have helped. Not 100% but a definite improvement.
no issues with the props off.
Thank you!
Hi Dave, Yes i did exactly that. I also tried to adjust individual motors that were starting normally to see the effect. In the end i left...
I hit all and just number 5. In both cases it didn't help.
I gave that a shot this morning and it only seemed to make things worse. A few of the other motors became a tad sluggish and no improvement on the...
I'm using a Quadro 2xl board which makes swapping out one BL Impossible (at least for me). It's a new board and the problems were there from the...
I'm now getting a I2C error and all eight BL's have the red green LED's on. Would one bad controller cause them all to fail?
Thank you for the input. I tried motor number 3 on PDB address 5 and it moved over to that motor so it must be a board issue. I've emailed...
Aircraft Type: CS8, MT3515-15 400kv, New MK Quadro 2xl ESC and New FC 2.5 Gimbal Type: AV200 Camera/Lens Being Flown: MK Stack: FC 2.5/Firmware...
Question for you David....I fly my IQ260 on a CS8 but have been afraid to turn on the wifi and possibly interfere with the Tx/RX signal. Is it...