/dist/images/branding/favicon
Separate names with a comma.
Bonjour Chris, I am powering my FC from the 4S through the FF dist. board. And take the 5v from the FC to the I2c converter and it's work fine. I...
bonjour Wolfgang, have you found what was the problem on your Navi Board? merci.
Yes, find it! My fault... There is no colour on esc wires. So when connect on the NAZA the key of the connectors are down. I have connect the same...
Bonjour, the auto sense is working with the NAZA. I'M thinking of a sequence in power on. I have a GAUI 330x with a Fyetech controleur, and I have...
I have reinstall the NAZA, same setup, only replace MK and i2c. You can ear the normal beep. So motors and esc should be OK. I don't know where to...
Bonjour, yes, if you mean to tell that it's a Graupner. I can see the voltage on the telemetrie of my radio. 16.7v. It's really look like the esc...
Bonjour, when you callibrate the i2c with the bind plug, do you ear the 4 tones for 4s lipo? I do not. I only have a slow repeating tone like the...
bonjour, I can ear the 4 tones on your start sequence for the 4s lipo. On mine, I have the 3 first tones but not follows by the 4 tones for the...
Yes, I have fix the jumper for 6 motors. do you have to calibrate the esc alone? Are you using 4s?
Bonjour, here is a short video of the startup: [media] merci
Here is the MK FC
Bonjour, it's look like it does not detect the 4s lipo. Normaly we have 3 tones followed by 3 or 4 more tones depending on the lipo. I have the 3...
Bonjour, need help! I have install the i2c converter as they said. Make the setup for six motors with FF esc. connect to MK FC2.1 Power the FC...
Bonjour, I'm using the FF motor control on a Y6 with NAZA v2, and it's work fine. Now I have order the I2c converter and will try with MK...
Bonjour, I am asking myself the same question. I am building a Y6 with the NAZA and the FreeFly esc. I have just made a small test with a simple...